geoGPS

VOLUME

How to calculate volume: cut, fill and balance

The Volume tool computes the volume between two surfaces, split into cut and fill. The result is recalculated after every change, and you can create a report at the end.

Updated: 31 Oct 2026 · 3 min read

Step-by-step calculation

Open Volume from the side menu (an active subscription is required). The switch in the sheet decides what your pick on the map goes to.

  1. Area (optional) – pick an area object that limits the calculation.
  2. Bottom – pick at least 3 points with an H height, or tick Level H and enter a constant height.
  3. Top – do the same for the upper surface.
  4. Read the result in the sheet at the bottom of the screen.

Without a picked area, the common extent of both surfaces is computed. When both surfaces are levels, you have to pick an area.

Reading the result

ValueMeaning
CutThe volume where the top lies above the bottom.
FillThe volume where the top lies below the bottom.
BalanceCut minus fill: positive means more cut, negative means more fill.
Computed areaThe area on which the volume was actually computed.
What to pick as bottom and top. The names follow only from the position of the surfaces. To compute cut against a design, pick the existing terrain as Top and the designed bottom as Bottom.

Check the triangle mesh

The app builds a triangle mesh from the points of each surface and draws it on the map. It is worth checking, especially on slopes and at the edges of the terrain. In triangle editing you can tap a triangle to delete it or flip its diagonal, and restore the automatic mesh at any time.

Mesh corrections can be lost. Adding or removing a surface point rebuilds its triangles, and earlier corrections disappear.

Report and DXF

  • REPORT (PDF) holds the date, coordinate and height systems, method, area, lists of bottom and top points, the calculations and the final balance.
  • DXF holds 3D points with height labels, triangles as 3DFACE, and outlines, on separate layers.
Closing the tool clears your picks and the result, which are not saved anywhere. To keep them, create a report or DXF first.

Frequently asked questions

Why doesn't the tool show a result?

Each surface needs at least 3 points with an H height or a level H. The points cannot lie on one straight line, and the surfaces must have a common extent.

What does the warning about different height systems mean?

The points have heights in different height systems, so the result includes the difference between them.

Can I calculate volume in the Web Panel or QGIS?

No. The Volume tool is available only in the mobile app.